Dell PowerConnect J-EX Series Release Release - Pagina 5
Blader online of download pdf Release Release voor {categorie_naam} Dell PowerConnect J-EX Series. Dell PowerConnect J-EX Series 14 pagina's. Release notes junos version 10.2
Pagina afdrukken
Layer 2 and Layer 3 Protocols
Management and RMON
Packet Filters
Related Topics
Changes in Default Behavior and Syntax in JUNOS Release 10.2 for J-EX Series Switches
Changes in Default Behavior and Syntax in JUNOS Release 10.2 for J-EX Series Switches
disable distributed PPM and run PPM just on the Routing Engine only if there is a
compelling reason to disable distributed PPM.
Enhancements to LCD menus—Using CLI commands, administrators can disable the
menu, the
Status
Maintenance
from viewing certain details about the switch and from configuring and troubleshooting
the switch from the LCD menu.
IPv6 path maximum transmission unit discovery—The IPv6 path maximum
transmission unit (MTU) discovery feature is now available on J-EX8200 switches.
IPv6 virtual routing and forwarding (VRF) multicast—IPv6 multicast traffic is now
supported for VRF on J-EX4200, and J-EX8200 switches.
802.1ag OAM support on J-EX4200 switches—802.1ag is an IEEE standard for
connectivity fault management (CFM). The following features are supported: continuity
check protocol, linktrace protocol, and loopback protocols.
sFlow enhancements on J-EX Series switches—You can configure the IP address to
be assigned to the sFlow agent and the IP address to be used in sFlow datagrams. By
configuring the IP addresses, you can ensure that the IP addresses are not dynamic
and do not change when the switch restarts.
Enhancements to firewall filter actions supported on J-EX8200 switches—The
, and
actions are now supported for ingress firewall filters on J-EX8200
reject
syslog
switches. The
action is supported on Layer 3 interfaces (router firewall filters)
reject
only.
Changes in Default Behavior and Syntax in JUNOS Release 10.2 for J-EX Series Switches
on page 5
Limitations in JUNOS Release 10.2 for J-EX Series Switches on page 6
Outstanding Issues in JUNOS Release 10.2 for J-EX Series Switches on page 9
The following changes in system behavior, configuration statement usage, or operational
mode command usage have occurred since the previous release and might not yet be
documented in the JUNOS Software for J-EX Series switches documentation.
Access Control and Port Security
The following enhancements have been made to the
The
show lldp local-information
management address and type.
menu, and the options in these menus to prevent users
show lldp
command now includes information about the local
log
,
commands:
5