3 Day Blinds VINYL BLINDS Aan de slag - Pagina 4

Blader online of download pdf Aan de slag voor {categorie_naam} 3 Day Blinds VINYL BLINDS. 3 Day Blinds VINYL BLINDS 10 pagina's.

Pagina afdrukken

TO INSTALL CENTER SUPPORT BRACKET(S):

If your hardware packet includes one center support

bracket, position it as close to the center of the mounting

surface as possible, making sure it will not interfere with

any moving parts. If more than one center support bracket

has been provided, position them equidistant from the end

brackets and each other, again avoiding all moving parts.

Proceed to "Blind Installation".

| Vinyl Blinds

• Make sure all center

support brackets are

positioned at the same

height and are level with

the end brackets.

• Using a pencil, mark the

mounting surface through

the holes in the back

of the center support

bracket. For maximum

stability, the pencil marks

should be made in the top

two holes of the center

support bracket.

• Using a drill with a

" drill

bit or an awl, make a small

pilot hole at each pencil

mark.

• Mount the bracket

using two of the screws

provided.

• Repeat this procedure

for any remaining center

support bracket(s).

BLIND INSTALLATION

• If you have not already done so unwrap the cellophane from

around the blind stack. Caution: DO NOT cut the cellophane

as the cords or ladders supporting the blind may be

inadvertently cut.

• Insert the headrail into the end brackets, making sure that

no cords or slats are in the way.

• Close the hinges on the end brackets until you hear them

"snap."

• While supporting the bottom of the blind, unwind the draw

cords and gently lower the blind to its full length.

Proceed to "Valance Installation."

• If you have ordered a

blind with a valance,

snap the regular valance

clips to the front of the

headrail. The regular

valance clips should be

spaced equidistant from

the end brackets and each

other to allow proper

support for the entire

valance.

• Also, for an outside

mounted blind attach the

button valance clips to the

side of the headrail prior

to installing the blind.

• You will install the valance

slats after the blind is in

place.

• Be sure the hinged end

brackets are in the open

position.