Dell PowerEdge 6400 Handmatig - Pagina 11

Blader online of download pdf Handmatig voor {categorie_naam} Dell PowerEdge 6400. Dell PowerEdge 6400 15 pagina's. Wake-on-lan (wol) support on dell servers
Ook voor Dell PowerEdge 6400: Installatie rek (37 pagina's), Upgrade installatiehandleiding (42 pagina's), Installatie rek (34 pagina's), Installatiehandleiding (42 pagina's), Installatiehandleiding (37 pagina's), Handmatig (10 pagina's), Installatie (4 pagina's), Montage en installatie (32 pagina's), Handmatig (10 pagina's)

6. The system will shut off. The connection LED on the NIC and switch or hub

will remain on indicating the NIC is monitoring the network for wake up

packets directed to its MAC address.

7. Send a wake up signal to the MAC address of the WOL enabled NIC, and the

system will boot.

Note: If the system boot is interrupted before the operating system (OS) and the NIC

driver are loaded, the system will not be able to perform WOL again until the system is

rebooted manually and the OS and driver are allowed to load and reset the NIC's WOL

registers.

PowerEdge 350 Note: The PowerEdge350 is the only Dell server that supports Standby

and not Hibernate. The same procedures should be followed with the exception of the

Hibernate enabling step and the shutdown to hibernate. Standby is enabled by default.

Send the system in to standby by clicking Start/Shut Down then choosing Standby.

October 2007

Page 11

Dell Enterprise Product Group