Dell PowerEdge M820 Systems Gebruikershandleiding - Pagina 12

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Dell PowerEdge M820 Systems. Dell PowerEdge M820 Systems 23 pagina's. Dell poweredge blade servers getting started guide
Ook voor Dell PowerEdge M820 Systems: Informatie-update (38 pagina's), Release-opmerkingen (27 pagina's), Belangrijke informatie Handleiding (35 pagina's), Handleiding bijwerken (32 pagina's), Handleiding bijwerken (28 pagina's), Gebruikershandleiding (26 pagina's), Gebruikershandleiding (22 pagina's), Aan de slag handleiding (12 pagina's), Gebruikershandleiding (3 pagina's), Technisch handboek (46 pagina's), Portfolio Handleiding (27 pagina's), Aan de slag handleiding (14 pagina's), Aan de slag handleiding (12 pagina's), Technisch handboek (47 pagina's)

Rev 1.0

2.4.3 Installation Safety Warnings

1. Installation Instructions

2. Over-temperature

3. During Lightning - Electrical Hazard

4. Copper Direct Attached SFP+ Cable Connecting/Disconnecting

Equipment Installation

6. Equipment Disposal

7. Local and National Electrical Codes

8. Hazardous Radiation Exposure

Read all installation instructions before connecting the equip-

ment to the power source.

This equipment should not be operated in an area with an ambi-

ent temperature exceeding the maximum recommended: 40°C

(104°F). An air flow of 9CFM at this maximum ambient temper-

ature is required.

During periods of lightning activity, do not work on the equip-

ment or connect or disconnect cables.

Copper Direct Attached SFP+ cables are heavy and not flexible,

as such they should be carefully attached to or detached from the

connectors. Refer to the cable manufacturer for special warnings

and instructions.

This equipment should be installed, replaced, or serviced only

by trained and qualified personnel.

Disposal of this equipment should be in accordance to all

national laws and regulations.

This equipment should be installed in compliance with local and

national electrical codes.

Caution – Use of controls or adjustment or performance of procedures

other than those specified herein may result in hazardous radiation

exposure.

Installation and Basic Operation