Dell S4148F-ON Series Installatiehandleiding - Pagina 42
Blader online of download pdf Installatiehandleiding voor {categorie_naam} Dell S4148F-ON Series. Dell S4148F-ON Series 47 pagina's.
Ook voor Dell S4148F-ON Series: Installatiehandleiding (48 pagina's)
Pagina afdrukken
IEEE standards
The S4100–ON Series (S4128F-ON and S4148F-ON) switch complies with the following IEEE standards:
•
802.1ab (LLDP)
•
802.1ax (Layer 2)
•
802.1d, 802.1w, 802.1s, 802.1x (Mgmt/Security), 802.3x (Layer 2)
•
802.3 (1000BASE-KX)
•
802.3ba (40 GbE and 100 GbE ports)
Agency compliance
The S4100–ON Series (S4128F-ON and S4148F-ON) switch complies with the following safety and agency requirements:
USA Federal Communications Commission (FCC)
statement
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules.
These limits are designated to provide reasonable protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy. If it is not installed and used in accordance to the
instructions, it may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference, in which case users will be required to take whatever measures necessary to correct the interference at their own
expense.
Properly shielded and grounded cables and connectors must be used in order to meet FCC emission limits. Dell EMC is not responsible for
any radio or television interference caused by using other than recommended cables and connectors or by unauthorized changes or
modifications in the equipment. Unauthorized changes or modification could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Figure 22. Canadian department of communication statement
European Union EMC directive conformance
statement
This product is in conformity with the protection requirements of EU Council Directive 2004/30/EC on the approximation of the laws of
the Member States relating to electromagnetic compatibility. Dell EMC cannot accept responsibility for any failure to satisfy the protection
requirements resulting from a non-recommended modification of this product, including the fitting of non-Dell EMC option cards.
This product has been tested and found to comply with the limits for Class A Information Technology Equipment according to CISPR 32/
CISPR34 and EN55032 / EN55034. The limits for Class A equipment were derived for commercial and industrial environments to provide
reasonable protection against interference with licensed communication equipment.
42
Specifications