Entec Solar E-1000 Snelstarthandleiding - Pagina 13

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Entec Solar E-1000. Entec Solar E-1000 17 pagina's.

After performing the measurement the data will show on the screen for a few

seconds. After that, the device will go back to the standby mode.

Keep in mind that the same button is used to power on, measure and power off the

device, so you have to be cautious when pressing it. It is important that you do not

press the button several times or for way too long.

When measuring strings of modules, it is recommended to measure the temperature

of at least three modules of the string. One module close to the ending and two

modules on the enter of the string. It is also recommended to measure the sport

indicated in the following picture:

Figure 6. An example of temperature

measurement locations within a module according to IEC 61853-1.

6 Report geration

At the end of the day, after ﬁnishing measuring, it is recommended to generate a

report with all the measurements performed that day.

The report is generated as a '.csv' ﬁle and includes the most important values of the

measured curves.

To generate a daily report, you may follow these steps:

1. Make sure that all the curves are on the SD card, and that the card is properly

inserted into the device.

2. Inside the Settings menu, press "Report generation"

3. Select the date you wish to create the report.

4. Press the generate button and wait for it to be generated. Once it is done, it will

be automatically saved to the SD card.

"Innovative technological developments for the solar photovoltaic industry"