AVZ Picca Installatie-instructie - Pagina 5

Blader online of download pdf Installatie-instructie voor {categorie_naam} AVZ Picca. AVZ Picca 7 pagina's. Folding arm awning

Pagina afdrukken
AVZ Picca Installatie-instructie
Assembly instructions folding arm awning Picca®
1.
Before placing the awning, make sure that the underlying structure is suitable for the
attachment of a folding arm awning (consult a structural engineer, if necessary).
2.
Provide sufficient fastening materials for your selected combination of wall and folding
arm awning (request advice from your supplier of fastening materials).
3.
Measure out holes for the walls of boards and central bracket. Drill holes in the wall.
NB: Top cover supports M10 bolts and central bracket M6 bolt (if
possible, drill a hole for the central support for better positioning).
4.
In case of electric controls: Drill a hole in the wall for the wiring.
5.
Place the screw stud with nut or bolts in the plugs/chemical anchors
into the wall so that the wall brackets can be placed with the keyhole
over the nut.
6.
Hang the folding awning with the wall brackets against the wall.
7.
Fasten the wall support bolts. Ensure that the wall brackets are level
with one another and are vertically level with the wall.
NB: In case of all awnings, an uneven position of the top cover supports will result in an
unequal position of the arms as a result, the awning will not function properly.
8.
Fasten the central bracket. When doing so, make sure that the top
cover does not sag.
9.
Place a turn rod in case of gear box or connect a motor. Use the
instruction manual of the chosen motor and extend the awning to its
furthest position.
10.
Set the desired awning angle between 5° and 35°. Adjust the awning
by slightly loosening the arm holder bolts and subsequently turning
(either in or out) the adjusting bolt between the fabric and arm.
(Tip: Lifting the front profile makes it easier to turn the bolt). Make sure that the front
profile runs parallel to the top cover in the open position. As soon as the desired
position has been realised, fasten the arm holder bolts.
11.
Nearly close the awning (leave 30 cm open) and align the front profile so that it follows
the contour of the top cover supports.
12.
Close the awning and check that the front profile falls neatly into
place. Is the central bracket positioned properly? Does the front profile
follow the contours of the top cover support? If not, make
adjustments.
13.
In case of electric controls, adjust the motor using the accompanying
manual.
Picca EN 20-03-2017
Parallel
page 5