EarthQuake MC43RCE Gebruikershandleiding - Pagina 9

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} EarthQuake MC43RCE. EarthQuake MC43RCE 10 pagina's. Mini-cultivator

Ek43 BORDER-EDGER kIT INSTallaTION (OPTIONal aCCESSORy)

The Border-Edger Kit is a useful tool for making clean cuts in

the lawn along the borders of gardens, flower beds, walkways,

and driveways for a well manicured look. To install the Border-

Edger Kit, do the following:

1. Disconnect spark plug wire from spark plug.

2. Remove the cotter pins from both sides of the tine shaft.

3. Remove the cultivating tines from the shaft, remembering

which direction they are facing.

4. Put the tines in a safe place and save the (2) cotter pins, they

will be used on the Border-Edger Kit.

5. Slide the Border-Edger attachment on either side of the

tine shaft. Make sure that the hub collar of the border edger

tine faces outward, away from the transmission of the mini-

cultivator.

6. Put (1) cotter pin, flat side facing edger attachment, through

the shaft hole that is further down the shaft from the hole

where the cultivating tines were placed.

7. Slide the wheel on the opposite tine shaft.

8. Insert the remaining cotter pin, flat side facing wheel, through

the hole next to the wheel at the end of the tine shaft.

9. Re-connect spark plug wire.

10. Before using the Border-Edger Kit, remove the drag stake from

the unit.

11. Set the mini-cultivator wheels to their highest (top) position.

BE aWaRE THaT THE mINI-CUlTIVaTOR COUlD UNEx-

PECTEDly BOUNCE UPWaRD, OR JUmP FORWaRD IF

THE TINES STRIkE CONCRETE, PaVEmENT, OR OTHER

HaRD SURFaCES OR HaRD OBSTaClES BURIED UN-

DER GROUND.

46134

cotter pin

EK43 Border-Edger Attachment Kit (fits both Models MC43 & MC43E)

Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5

MC43 Series Mini-Cultivator

CaUTION

4651

46131

tine shaft

wheel

Operator's Manual

46130

border-edger tine

46134

cotter pin

Revised 4.16.08