EarthQuake DJ-ARRAY GEN2 Gebruikershandleiding - Pagina 8
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} EarthQuake DJ-ARRAY GEN2. EarthQuake DJ-ARRAY GEN2 12 pagina's. Line array speaker system
Pagina afdrukken
CONNECTING DJ-ARRAY GEN2 SPEAKERS
The DJ-Array GEN2 speakers are equipped with
1/4" TRS input connectors at the bottom portion
of the mounting bracket. With the supplied TRS
cables, gently push one end of the TRS cable plug
into the input as shown below and push the other
end into your amplifier or powered subwoofer.
Left Array
Using the supplied 1/4" TRS cables, connect left
and right DJ-Array GEN2 speaker systems to the
left and right array inputs located on the back of
the DJ-Quake Sub v2 or any other amplifier that
supports 1/4" TRS inputs. You do not need to run
any other speaker cables for these array speakers
due to the convenient internal wiring inside the
mounting bracket.
8
DJ-Array GEN2 Manual
DJ-Quake Sub v2
Earthquake Sound Corp. | (510) 732-1000 | www.earthquakesound.com
The DJ-Quake Sub v2 is a great choice to pair with
these array speakers as it features multiple inputs
and outputs as well as an active 12 inch sub-
woofer to create the ultimate and portable DJ
system.
Right Array
HUM Kleaner
Earthquake strongly recommends using the HUM
Kleaner active line converter and pre-amplifier
when your audio system is susceptible to noise at
the source or when you need to push an audio
signal through long wire runs. Please refer to the
manual before setting up and using this product.