Award PM60 Bedienings- en installatie-instructies - Pagina 8

Blader online of download pdf Bedienings- en installatie-instructies voor {categorie_naam} Award PM60. Award PM60 13 pagina's. Built-in vitroceramic hob

Pagina afdrukken

ELECTRICAL CONNECTION OF YOUR HOB

· Before proceeding with the electrical connection, verify that the current

carrying capacity of the system and the socket is adequate for the maximum

power rating of the hob.

· Electrical installation of the residence and the electrical current plug in

u se mu st be ea rthe d and co nfo rm wi th sa fety re gul ati ons .

· If there is no dedicated hob circuit and fused switch, they must be installed

by a qualified electrician before the hob is connected.

. Fused switch must be easily accessible once the hob has been installed.

· Do not use adaptors, multiple sockets and/or extension leads.

· This appliance conforms with the requirements ofthe following EEC

Directives:

1. Vitroceramic hob EEC/73/23 and 93/68, EEC/89/336 relating to

radio interference,

2. EEC/89/109 relating to contact with foods.

· A circuit breaker with a contact opening of at least 3mm, rated 32A and

delayed functioning type must be installed inside the supply circuit.

· For the knob controlled vitroceramic hob, the cable must be H05VV-F

5X1,5mm² for 3 phase or 3X2,5mm² for single phase / 60227 IEC 53.

You will find the connection diagram shown on the bottom of your appliance.

* This appliance must be earthed.

* For this connetion a power lead of wire type

H05VV -F should be used.