EarthWay 2130 Montage-instructies - Pagina 3

Blader online of download pdf Montage-instructies voor {categorie_naam} EarthWay 2130. EarthWay 2130 5 pagina's. High-output broadcast spreader
Ook voor EarthWay 2130: Montage- en bedieningshandleiding (4 pagina's)

Pagina afdrukken

65 lb. Professional

Ice Melt Spreader

MODEL # 90365

ASSEMBLY INSTRUCTIONS

Step 5: Install handle shaft to lower handles and pivot & bracket assembly as shown

using 2" bolts and locknuts. TIGHTEN BOLTS AND NUTS NOW.

Step 6: (This step is only required if you want to change the position

of the handles). NOTE: BEFORE INSTALLING GAUGE AND UPPER

HANDLES TO HANDLE SHAFT, UPPER HANDLES FEATURE THREE

POSITONS FOR OPERATOR'S COMFORT. If operator chooses middle

or upper positions, use handle spacer in hole nearest to handle

grips.

Insert 2" bolt through upper handle, then through handle spacer

through other upper handle and secure with locknut. DO NOT

TIGHTEN LOCKNUT YET. TIGHTEN THIS NUT LAST.

Now slide the UPPER HANDLE assembly over the HANDLE SHAFT

(on the end with the bolt holes closer to the

end). Install gauge & lever using (2) 2" bolts. Be

sure gauge is on left hand side. Tighten locknuts

to gauge first. TIGHTEN ALL HARDWARE NOW.

Step 7: Install Control Rod by inserting flattened

end of Control Rod into Lever on Gauge as

shown. Turn to lock in place. {Make sure that

there is a plain ¼ -20 Hex Nut threaded about

halfway up the threads}.

Push lever forward to full OPEN setting. Align

and push the Control Rod through the angle attached to the Pivot

Bracket. Now install ¼ -20 regular nut on to Control Rod. {One

nut on either side of the angled plate}.

Next pull pivot & bracket back so that the shut off plate in the

hopper is in the full open position and adjust the Hex Nuts on the

Pivot Bracket angle to secure the angled bracket. Now tighten the

nuts against the pivot angled bracket to prevent change in

calibration.

90365 65lb Ice Melt Spreader_M53107_113020

PAGE 3