EarthWay 2170 Montagehandleiding - Pagina 7

Blader online of download pdf Montagehandleiding voor {categorie_naam} EarthWay 2170. EarthWay 2170 12 pagina's. Commercial broadcast spreader with side spread control
Ook voor EarthWay 2170: Montage- en bedieningshandleiding (6 pagina's), Montage- en bedieningshandleiding (8 pagina's), Gebruiksaanwijzing (8 pagina's), Montage- en bedieningshandleiding (6 pagina's), Montagehandleiding (10 pagina's)

Assembly and Operation Instructions

Install flattened end of control rod in to lever

Step 15:

on gauge as shown. Turn to lock in place. Next push lever

forward to setting "0". Align control rod with hole in

pivot bracket, pull lever backward to insert control rod

through hole in pivot bracket. Now install ¼-20 Hex nut

on to control rod.

Pull lever back to setting "30" as shown. Next

Step 16:

push pivot & bracket forward so that the shut off plate in

the hopper is in the full open position. REMEMBER

SETTING "30" ON THE FLOW CONTROL LEVER MUST

PLACE THE SHUT-OFF PLATE IN THE FULL OPEN

POSITION TO BE PROPERLY CALIBRATED. Now tighten

the nuts against the pivot bracket to prevent change in

calibration.

NOTE: Tension on the flow control lever may be

adjusted by tightening or loosening the tension nut as

shown.

Insert agitator to pinion shaft on inside of

Step 17:

hopper.

Note: the position of flat side of the agitator. This pin

should be installed as shown.

Install debris screen into hopper, then insert ¼-

Step 18:

20 x 1" Stainless Steel Hex Bolt thru the hole in the side

wall of the hopper. Secure with Stainless Steel lock nut.

TIGHTEN WITH HAND TOOLS ONLY.

P2170_M52164_Rev_May2020_compressed

PAGE 7