EarthWay EV-N-SPRED C24HDS Montage- en bedieningshandleiding - Pagina 3
Blader online of download pdf Montage- en bedieningshandleiding voor {categorie_naam} EarthWay EV-N-SPRED C24HDS. EarthWay EV-N-SPRED C24HDS 10 pagina's. Broadcast spreader
Ook voor EarthWay EV-N-SPRED C24HDS: Montage- en bedieningshandleiding (9 pagina's)
Pagina afdrukken
Drive wheel side
2" Cotter Pin
Install the axle
as shown above
Coast wheel side
1" Cotter Pin
6. Install the axle through the lower handle and then the gearbox and finally, through the other lower handle.
Now install the drive wheel to axle using pin hole nearest to lower handles as shown. Insert 2" cotter pin through wheel and
through axle. Bend with pliers to prevent pin from falling out.
NEXT Install coast wheel to axle, and then using outside pin hole on the axle (as shown on the left), insert 1" cotter pin through
axle [NOTE: The cotter pin does not go through the wheel]. Bend with pliers to prevent pin from falling out.
TURN SPREADER UPRIGHT ON TO WHEELS
7. NOTE: BEFORE INSTALLING THE GAUGE &
LEVER ASSEMBLY AND UPPER HANDLE TO THE
2 Position Handle
¼-20 x 2¾"
HANDLE SHAFT, SELECT THE BEST POSITION
Hex Head Bolt
FOR THE OPERATOR'S COMFORT. You can select
Lower Position
lower or upper positions for best fit to the operator's
height. Insert 2 ¾" bolt through the Gauge, then upper
Upper Position
handle and finally through handle shaft. See example
to the right.
DO NOT TIGHTEN LOCKNUT YET.
8. Insert pivot rod into shut off plate as shown below.
¼-20
[TIP: Insert rod end from the top, then push down &
Lock Nut
¼-20 x 2¼"
turn to lock in place.]
and
Hex Head Bolt
9. Insert other end of pivot rod into pivot and bracket
(Cupped Washer
and (Cupped Washer
for C24HD)
for C24HD)
assembly as shown. [TIP: Insert rod end from the side
that has the angle attached to the bracket, then turn
to lock in place as shown at the right and above. The
correct positioning of the Pivot Bracket has the Angle
and Attaching Arm facing away from the gearbox.]
Angle
Insert Pivot Rod
into Shut-Off
and rotate to secure
n
Otice cupped wAsher lOcAtiOns
Attaching
Arm
c24hd
fOr
Assembly
PAGE 3