360 Vision Vision i Dome Installatie- en configuratiehandleiding - Pagina 19

Blader online of download pdf Installatie- en configuratiehandleiding voor {categorie_naam} 360 Vision Vision i Dome. 360 Vision Vision i Dome 20 pagina's.

Pagina afdrukken

360 Vision Vision i Dome Installatie- en configuratiehandleiding

Vision i Dome_VisionDome VR Installation Manual Ver 3.1

Privacy Zone Menu (Not available on Vision i Dome)

Can be used to obscure a scene within an image e.g. private residence. Move the camera to the position

required for the privacy zone before going into the camera OSD. You cannot manually move the camera once

in the OSD. Use the zoom to set the size of the privacy zone. Privacy zone will cover the whole scene viewed

when set.

•

Define Privacy Zone - Used to set a privacy zone.

•

Seek Privacy Zone - Used to seek a privacy zone.

•

Remove Privacy Zone - Used to remove a privacy zone.

12 Important - Care of Painted Surfaces

The powder coating applied to the VisionDome external housing is recognised as being in the forefront for

quality and finish. However, in order to preserve the aesthetic finish it is recommended that the coating is

regularly cleaned.

Regular cleaning on a maximum three month interval, using warm and mild detergent must be undertaken.

Abrasive cleaners including strong solvent must NOT be used at any time.

In areas where the coating may come in contact with concentrated atmospheric pollutants [marine, chemical

and especially bird droppings] it would be prudent to clean more frequently e.g. monthly.

Full documentation of the cleaning schedule MUST be maintained to ensure that a warranty claim can be

considered.

If damage occurs to the coating (e.g. the VisionDome is dropped, scrapped etc), repairs MUST be carried out

immediately.

When the VisionDome is installed in areas where there is a high risk of damage from birds or their droppings,

additional precautions and measures should be used to keep the birds away from the VisionDome e.g. fit anti-

bird spikes.

13 Storage and Handling

Visiondomes should be handled with care and must not be dropped. When Visiondomes are inside the transit

packaging which is used for despatch from the factory, they should not be stacked to a height of more than two

Visiondomes.

When Visiondomes are being stored before installation they should be kept in the transit packaging and located

in a dry indoor environment preferably between 1°C and 35°C which is dry and dust free. Humidity should such

that water vapour is non-condensing. Visiondomes can be allowed to be outside this range for short periods

of time (24 hours maximum) for transport (e.g. in aircraft or vans) but must never be allowed to be outside the

normal operating temperature range of -40°C to +60°C even during storage.

Before installation the Visiondome should be clean and dry. (If necessary it should be cleaned and dried taking

care that the cover is not scratched).

14 Warranty

This information and/or any technical information – whether received verbally or writing – is given in good faith

but without warranty and this also applies where proprietary rights of third parties are involved. The information

provided does not release you from your obligation to check its validity and to test the products suitability for

the intended purpose(s) and use(s). The application, use and installation of the products either in isolation or in

conjunction with other products used, provided and installed by you on the basis of the technical advice issued

are beyond our control and therefore remain entirely your own responsibility.

Page 19