ALLLED DynColor DC300-RL-RGB-PP Gebruikershandleiding - Pagina 3

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} ALLLED DynColor DC300-RL-RGB-PP. ALLLED DynColor DC300-RL-RGB-PP 6 pagina's. Dyncolor 300-rl rgb dmx controllers

Pagina afdrukken

Page 3 of 6

Create a Layout Plan drawing, per a Lighting Designer's or Architect's recommendation.

Consult ALLLED Representative as needed.

Installation Considerations

When creating your installation plan, consider the following:

1) Location of the controller

ALLLED recommends that the controller is placed in dry environment.

2) Selection of soldering tools

Ensure that the tool selected is appropriate for the soldering surface.

3) Length of rope light

Rope lights can be cut or connected to adjustable lengths. For 240VAC, minimum cut is every 2 meters

(6.6 feet); For 120VAC, minimum cut is every 1 meters (3.3 feet). The rope light shall be cut exactly at the

cutting mark.

4) Maximum Driving Quantity

50 meters

Installation Steps

1) Make sure the switch is keeping off before wiring or installation.

2) Connect rope light to the data wire on the controller.

3) Connect power plug to power connector on the controller, and plug it into the power outlet.

4) Plug the power adaptor into the controller, and plug it into the power outlet.

5) Switch on the controller, choose the desired color pattern, and set changing speed etc.

Wiring Diagram

Function Introduction

1) Physical Specifications

Dimension: L190 x W120 x H50 mm

Weight: 830g

Working Environment: dry environment

Buttons: MODE, SETUP, UP & DOWN