Miele DA 2390 Bedienings- en installatie-instructies - Pagina 29

Blader online of download pdf Bedienings- en installatie-instructies voor {categorie_naam} Miele DA 2390. Miele DA 2390 36 pagina's. Ventilation system
Ook voor Miele DA 2390: Bedienings- en installatie-instructies (40 pagina's), Bedienings- en installatie-instructies (40 pagina's), Bedienings- en installatie-instructies (36 pagina's), Bedienings- en installatie-instructies (40 pagina's), Bedienings- en installatie-instructies (36 pagina's)

Pagina afdrukken
Miele DA 2390 Bedienings- en installatie-instructies
 Fit one of the screws supplied into
each lamp holder.
 Tighten the screws with a screwdriver
until the frame sits flush with the
installation surface.
Do not overtighten the screws!
 Refit the lamps.

Connection for air extraction

Before installation, it is important
to read the information given on the
following pages as well as the
"Appliance dimensions" and the
"Warning and Safety instructions" at
the beginning of this booklet. This is
particularly crucial when using the
rangehood at the same time as a
heating appliance that relies on
oxygen from the same room, which
could result in the build-up of toxic
fumes.
The rangehood should be installed
according to local and national
building regulations. Seek approval
from the building inspector where
necessary.
Only use smooth pipes or flexible
ducting made from approved non-
flammable materials for exhaust
ducting.
To achieve the greatest possible air
extraction with the lowest noise level,
please note the following:
– The diameter of the exhaust ducting
should not be less than 150 mm.
– If flat ducting is being used, the
cross-section must not be smaller
than the cross-sectional area of the
exhaust connection.
– The exhaust ducting should be as
short and straight as possible.
– Only use wide radius bends.
– The exhaust ducting must not be
kinked or compressed.
Installation
29