Miele DA 5196 W EXT Handleiding voor installatie-instructies - Pagina 8

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Miele DA 5196 W EXT. Miele DA 5196 W EXT 20 pagina's. Cooker hood
Ook voor Miele DA 5196 W EXT: Bedienings- en installatie-instructies (48 pagina's), Bedienings- en installatie-instructies (48 pagina's)

Plywood backing

The majority of the weight of the

installed ventilation system will be

supported by the lower retaining

plate. It must be firmly attached to

the stud framing behind the drywall.

If studs are not available in the

required locations, a plywood

backing (min. ½" (13 mm) thick)

spanning at least two studs must be

installed.

Failure to adequately support the

weight as stated may result in the

ventilation system falling off the wall,

causing personal injury and property

damage.

If plywood backing is not needed,

proceed to the included "Installation

diagram".

To install a plywood backing

 Determine and mark the location of

the retaining plate  for the canopy

as outlined on the "Installation

diagram".

 Make a cutting line 3" (76 mm) above

and 3" (76 mm) below the outline of

the retaining plate.

 Find the studs  to the left and right

of the mounting location by tapping

the wall or using a stud finder.

 Mark a vertical cutting line along the

center of each stud.

CAUTION: When cutting or drilling

into the wall or ceiling, do not

damage electrical wiring and other

hidden utilities.

 Remove the drywall between the

cutting lines and replace it with

plywood  of a matching thickness

(min. ½" (13 mm) thick). Tape the

joints and refinish the wall.

 Proceed to the enclosed "Installation

diagram" to complete the installation.

Installation