Miele DAR 1230 Bedienings- en installatie-instructies - Pagina 26

Blader online of download pdf Bedienings- en installatie-instructies voor {categorie_naam} Miele DAR 1230. Miele DAR 1230 32 pagina's. Range wall / insert hood
Ook voor Miele DAR 1230: Bedienings- en installatie-instructies (22 pagina's), Bedienings- en installatie-instructies (40 pagina's), Bedienings- en installatie-instructies (40 pagina's)

Plywood backing

The majority of the weight of the

installed ventilation system will be

supported by the retaining plate. It

must be firmly attached to the stud

framing behind the drywall. If studs

are not available in the required

locations, a plywood backing (min.

½" (13 mm) thick) spanning at least

two studs must be installed. Failure

to adequately support the weight as

stated may result in the ventilation

system falling off the wall, causing

personal injury and property

damage.

(If plywood backing is not needed,

proceed to the included "Installation

diagram".)

To install a plywood backing

^ Determine and mark the location for

the canopy as outlined in "Appliance

dimensions".

^ Make a cutting line 3" (76 mm) above

and 3" (76 mm) below the outline of

the retaining plate.

^ Find the studs to the left and right of

the mounting location by tapping the

wall or using a stud finder.

^ Mark a vertical cutting line along the

center of each stud.

CAUTION

When cutting or drilling into the wall

or ceiling, do not damage electrical

wiring and other hidden utilities.

^ Remove the drywall between the

cutting lines and replace it with

plywood of a matching thickness

(min. ½" (13 mm) thick). Tape the

joints and refinish the wall.

^ Proceed to the enclosed "Installation

diagram" to complete the installation.