Miele Dynamic U1 Gebruiksaanwijzing - Pagina 17

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Miele Dynamic U1. Miele Dynamic U1 32 pagina's.
Ook voor Miele Dynamic U1: Snelle referentiehandleiding (8 pagina's), Snelle referentiehandleiding (8 pagina's)

Pagina afdrukken

Service indicator with reset button [

(see fig. 34)

The indicator light will come on after

approx. 50 hours of operation, which is

equivalent to one year of average use.

Check if the motor protection filter and

the exhaust filters need to be replaced

as well. You will need to reset the

indicator after replacing any of these

components.

To do this, the vacuum cleaner must be

turned on.

^ Press the reset button [.

The service indicator will go out and be

reset to its original position.

The reset feature only works

properly if the indicator light has

already come on, but not if the reset

button is pressed in between filter

changes.

Removing hair and threads from the

Powerbrush (see fig. 35)

^ Turn off the vacuum and unplug it

from the outlet.

^ Release the body of the vacuum

cleaner and lower it to the floor

(see fig. 12).

^ Turn the vacuum cleaner over.

^ Use scissors to cut any threads or

hair that have wound around the

roller brush. Guide the scissors along

the guide track on the beater bar.

The trimmings will be drawn into the

vacuum cleaner by the suction once

the vacuum cleaner is turned on.

Blockages (see fig. 36 + 37)

If there are large particles or other

blockages at the base of the suction

hose, you can open it up to clear the

passage.

^ Click the vacuum cleaner into the full

upright position.

^ Press the release button on the

telescopic wand and remove the

handle from the suction hose

^ Guide the swivel elbow at the end of

the suction hose over the catch

hooks, to increase the stability the

vacuum cleaner (see fig. 21).

Undo the suction hose in the

direction of the arrow.

Pull the suction hose connector off

the swivel elbow.

^ Remove all blockages

^ Put the connector back on and click

it shut.

If you still have not been able to remove

the obstruction(s), there is another

method you can try.

Open the service flap on the bottom

rear of the vacuum cleaner.

Use a coin to undo the two screws

until they stop.

Pry the service flap free.

^ Remove all blockages.

Put the service flap back on and screw

into place.