Miele K 12820 SD edt Bedienings- en installatie-instructies - Pagina 31
Blader online of download pdf Bedienings- en installatie-instructies voor {categorie_naam} Miele K 12820 SD edt. Miele K 12820 SD edt 44 pagina's. Refrigerator with dynamiccooling
Ook voor Miele K 12820 SD edt: Bedienings- en installatiehandleiding (48 pagina's), Bedienings- en installatiehandleiding (40 pagina's), Bedienings- en installatie-instructies (44 pagina's), Bedienings- en installatie-instructies (48 pagina's)
Do not place any appliance which
gives off heat, such as a toaster or
microwave oven, on top of this
appliance, as this would increase
the appliance's energy
consumption.
This appliance must not be installed
directly next to another refrigerator
or freezer.
It does not have side-wall heating,
so installation next to another
refrigerator or freezer could cause a
build-up of condensation between
them.
Further information is available from
your dealer.
Location
This appliance should be installed in a
dry, well-ventilated room. It should not
be installed where it is exposed to
direct sunlight or directly adjacent to a
heat-producing appliance such as an
oven or a radiator. The room
temperature should not go above or
below the climate range for which the
appliance is designed. The higher the
ambient temperature of the room, the
more energy the appliance requires to
operate.
Climate range
This appliance is designed for use
within certain climate ranges (ambient
temperatures), and should not be used
outside this range. The climate range of
the appliance is stated on the data
plate inside the appliance.
Climate range
SN
N
ST
T
Operating in a room which is too cold
will cause the cooling system to switch
off for too long, causing the internal
temperature in the appliance to rise.
Ventilation
Air at the back of the appliance gets
warm. To ensure sufficient ventilation,
the ventilation gaps must not be
covered or blocked in any way. They
should be dusted on a regular basis.
Installation
^ Remove the cable clip from the back
of the appliance.
^ Check that all parts at the back of the
appliance are unhindered. Carefully
remove any hindrance.
^ Carefully push the appliance into
position with the back against the
wall.
Installation
Ambient room
temperature
+10 °C to +32 °C
+16 °C to +32 °C
+16 °C to +38 °C
+16 °C to +43 °C
31