Miele CS 1028 Instructies omzetten - Pagina 3
Blader online of download pdf Instructies omzetten voor {categorie_naam} Miele CS 1028. Miele CS 1028 40 pagina's. Combiset
Ook voor Miele CS 1028: Bedienings- en installatie-instructies (44 pagina's), Bedienings- en installatie-instructies (44 pagina's), Bedienings- en installatie-instructies (44 pagina's), Bedienings- en installatie-instructies (44 pagina's)
Pagina afdrukken
The cooktop should have been ordered
for connection to either natural or LP
(propane) gas.
The included regulator corresponds
with the gas type of the cooktop. Verify
before installing. See, "To convert the
regulator".
If the appliance is to be connected to a
type of gas other than it was originally
configured for, both the regulator and
burners must be converted.
,
WARNING
The conversion kit must be
installed by a qualified technician
in accordance with the
manufacturer's instructions and
all applicable local and national
codes. If the information in these
instructions is not followed
exactly, a fire, explosion or
production of carbon monoxide
may result causing property
damage, personal injury or loss of
life. The qualified technician is
responsible for the proper
installation of this kit. The
installation is not proper and
complete until the operation of the
converted appliance is checked as
specified in these instructions.
Converting CS 1011
To convert the regulator:
^ Unscrew the hexagonal nut (brass
cap) located on the top of the
regulator.
^ Make sure that the spring stays in
place.
^ Take the plastic insert out and flip it
over.
The plastic insert is marked on either
end:
- NAT (Natural Gas)
- LP (Propane)
^ Set the plastic insert back into the
nut.
^ Screw the hexagonal nut back on the
regulator.
3