Miele GAS COMBISET CS 1012 Bedienings- en installatie-instructies - Pagina 13
Blader online of download pdf Bedienings- en installatie-instructies voor {categorie_naam} Miele GAS COMBISET CS 1012. Miele GAS COMBISET CS 1012 44 pagina's. Double gas combiset
Ook voor Miele GAS COMBISET CS 1012: Bedienings- en installatie-instructies (44 pagina's), Productafmetingen (4 pagina's), Instructies omzetten (40 pagina's)
![Miele GAS COMBISET CS 1012 Bedienings- en installatie-instructies](/uploads/products/server2/3448395/3448395.jpg)
Turning on
^ To turn on the burner, press the
control knob down to pass the
resistance, then release the pressure
and turn it counterclockwise to the
largest flame symbol. The ignitor will
"click" and ignite the gas.
If the burner does not ignite or the
flame goes out, turn the control knob to
"ß". Try again after a few seconds.
If the burner still won't ignite after the
second attempt, turn the control knob
to "ß" and see "Frequently asked
questions".
^ Adjust the knob to the desired
setting.
Regulating the burners
^ The burners can be variably adjusted
between the lowest and highest
flame by turning the control knob.
Since the outer portion of the flame is
much hotter than the center, the flame
should be set so that its tips do not
spread beyond the sides of the pan.
Flame tips which extend beyond the
sides of the pan are hazardous.
Turning off
^ Turn the knob clockwise to "ß".
This stops the flow of gas and turns off
the combiset.
On/Off indicator and Residual
heat indicator
When the combiset is turned on, the
On/Off indicator lights up. Once a
pre-set temperature has been reached,
the residual heat indicator will also light
up. The On/Off indicator goes out when
the combiset is turned off. The residual
heat indicator will remain on until the
combiset is cool enough to touch.
Do not touch or place any heat
sensitive objects on the combiset
while the residual heat indicator is
on. Danger of damage or injury.
If the display is flashing, a fault has
occurred. See "Frequently asked
questions".
Use
13