Dialog ROOM CONTROLLER WPP-INT Installatiehandleiding - Pagina 9

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Dialog ROOM CONTROLLER WPP-INT. Dialog ROOM CONTROLLER WPP-INT 10 pagina's. Daylight sensor

8. WIRING AND START-UP

Risk of Electric Shock. More than one disconnect switch is required to de-energize the device before servicing. All Servicing
should be performed by qualified service personnel. This unit has more than one power supply connection point. To reduce the
risks of electric shock disconnect both the branch circuit breakers / fuses & emergency power supplies before servicing.
A 24Vac data line source is used for the Dialog Occupancy Sensors, Daylight Sensors and Digital Wall Station Switches. All switches or loads
supported by the sensor must be included in the loading capacity of the Dialog Room Controller. Controller can support up to 100mA of
peripheral devices.
Use appropriate sized wire-nuts to connect the Dialog 2-wire network and external source to the auxiliary relay wires.
When using field-installed conductors ensure a 60ºC minimum rating.
1.
Connect wiring as shown on appropriate Kit Wiring Diagram
2.
Power up system
3.
Wait 15 seconds for system to start-up and run system checks
4.
Check sensor functionality
5.
Set Daylight level
a.
Remove face plate
b.
Press commissioning button (green LED flashes)
c.
Adjust dial to desired light level
d.
Step away from sensor until orange light flashes
6.
Installation & configuration complete!

9. LED STATUS INDICATORS

The sensor has green and orange LED lights in the lens to indicate "Commissioning in Progress" and "Commissioning Complete".
A UDLA Company
CAUTION
!
!
9
A UDLA Company