Alloy LED AL-60-03-0008 Specificaties en instructies - Pagina 3
Blader online of download pdf Specificaties en instructies voor {categorie_naam} Alloy LED AL-60-03-0008. Alloy LED AL-60-03-0008 7 pagina's. Led wifi controller hub
Pagina afdrukken
Using the WiFi Hub with the DMX Decoder (AL-60-03-0007)
(WiFi Hub connected to router via ethernet cable)
1. Connect the Radialux tape light(s) to the DMX Decoder(s) according to the instructions on the DMX Decoder specification sheet. Be sure to
install the decoders so they can be accessed later, the digital interfaces will be used to assign zones.
2. Important: They will need to connect via RJ45 cable back to the modem from the wifi hub.
3. If using multiple decoders, wire according to the diagram above.
4. Set the following addresses on the digital interface of each decoder. Each room may have multiple decoders. Decoders in the same room
get the same address. Push the first button on each decoder for a few seconds until the numbers blink. Then short press each button to
set the address. As an example, let's suppose there are five rooms. The decoder in each room will get one of the following addresses:
Room #1: 001
Room #2: 005
Room #3: 009
5. Download the LED WiFi Controller Hub application from the Apple app store or Google Play by searching for "easylighting" or scanning a
QR code (see previous page).
6. Open the app. Go to app 'Setting' then click the "Connect the WiFi LED controller to your home network" button. Link to your home
network.
7. Go to the 'Room' section of the app. In the "Room" section, the following are the default rooms: Bedroom, Kitchen, Washroom, Living
Room, and Bathroom. (Each of these rooms can be renamed after the process of assigning a light color to each room is complete.)
To match the order of the decoders to to the order of rooms in the app, assign each decoder a room in this order: Bedroom, Kitchen,
Washroom, Living Room, Bathroom, etc.
8. In the 'Room' section, choose what the room labeled 'Bedroom'. A green check mark will appear.
9. Go to the 'Setting' section again. Click the box that says "Use direct Easy Lighting connection with the WiFi LED controller"
10.
Click 'Yes' when this prompt appears: 'Your mobile phone is already connected to the WiFi controller?'
11.
Select the desired color on your color wheel.
12.
Go back to the 'Room' section. Uncheck the Bedroom and check the next room. Repeat steps 8, 9, and 10. Go through these steps
one room at a time. To assign different rooms the same color, check those rooms before selecting the color on the color wheel.
13.
Do not click 'Save', settings are automatically saved and clicking "Save" again will override your settings. and they may be lost.
www.AlloyLED.com
Page 3 of 7
®
®
router
Room #4: 013
Room #5: 017
|
Call: 800.910.LEDS [5337]
CAT5 extension cable
AL-60-99-0003
| Text: 510.400.6690
DC power
|
v2.3