Dialogic Vision TIGI2U Installing - Pagina 8

Blader online of download pdf Installing voor {categorie_naam} Dialogic Vision TIGI2U. Dialogic Vision TIGI2U 15 pagina's.

Installing the Dialogic® Vision™ Server TIGI2U

Connecting to a power source

If you are installing an AC server, connect a power cord to the AC connector on the

back of the server and plug the cord into an AC outlet.

To install a DC server, slide open the cover for the DC power connector and strip the

wire insulation back from the wire. Insert each wire all the way into the connector

and tighten the screw on top of the connector as shown:

Caution:

To connect to a 10Base-T, 100Base-T, or 1000Base-T network, use two shielded

twisted pair (STP) Category 5 or better Ethernet cables. The two 10/100/1000Base-T

Ethernet connectors provide the line card with Ethernet connections supporting auto-

negotiation for 10, 100, and 1000 Base-T full duplex and half duplex transmissions.

The following illustration shows pin assignments for the RJ-45 line card Ethernet

interfaces:

Arrow.com.

Downloaded from

The top cover must be fully closed before applying power to cables or attaching the

connector to the power supply.

P i n 1 : M D I 0 P

P i n 1

P i n 2 : M D I 0 M

P i n 3 : M D I 1 P

P i n 4 : M D I 2 P

P i n 5 : M D I 2 M

P i n 6 : M D I 1 M

P i n 7 : M D I 3 P

P i n 8 : M D I 3 M

P i n 8

M = minus

P = plus