ALLREDI MARCO 151E Gebruikershandleiding - Pagina 14
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} ALLREDI MARCO 151E. ALLREDI MARCO 151E 16 pagina's. Remote control switch
Pagina afdrukken
W-562
Always depressurize
the entire system,
disconnect all power
sources and lockout/
tagout all components
before any maintenance
or troubleshooting is
attempted. Failure to
comply with the above
warning could cause
electrical shock and
inadvertent activation of
equipment resulting in
death or serious injury.
Use a 16 gauge electric
cord for lengths up
to 300 feet. To reduce
electrical resistance, use
larger gauge electrical
cord for distances
greater than 300 feet.
13
Marco
151E Remote Control Switch
®
TROUBLESHOOTING
If the Marco
151E Remote Control Switch does not function properly, check the following:
®
SYMPTOM (Cause)
Remote Control Switch will not
activate when Remote Control Handle
is depressed
(Damaged components, Switch
requires adjustment, Damaged Electric
Control Line, Remote Control Switch
malfunction)
Remote Control Switch will not
deactivate when Remote Control
Handle is released
(Damaged components, Damaged
Electric Control Line, Remote Control
Switch malfunction)
ACTION
Handle is not making contact with Micro
Switch. Adjust height of Micro Switch per
instructions in this manual.
Inspect Micro Switch for visible damage. If
protective covering is damaged, replace Micro
Switch immediately.
Test electric continuity of Micro Switch.
Remove Micro Switch from Remote
Control Body. Remove Electric Plug from
Micro Switch. Test continuity of the Micro
Switch by placing the electrodes on each wire
and press Micro Switch. If no continuity is
detected, replace Micro Switch.
Inspect electric control line and connections
for damage. Test electric continuity of power
cord between Remote Control System and
Remote Control Switch. Repair or replace
damaged electric control line and connectors.
Electrical resistance in electric control line.
Replace power cord with larger gauge power
cord.
See remote control system Operator's Manual.
Ensure Handle returns to the up position.
Inspect Safety Tab and Springs for debris
or damage. Replace damaged components
immediately.
Inspect Micro Switch for visible damage. If
protective covering is damaged replace Micro
Switch immediately.
Test electric continuity of Micro Switch.
Remove Micro Switch from Remote
Control Body. Remove Electric Plug from
Micro Switch. Test continuity of the Micro
Switch by placing the electrodes on each wire.
If continuity is detected without pressing Micro
Switch, replace Micro Switch.
Inspect electric control line and connections
for damage. Test electric continuity of electric
control line between Remote Control System
and Remote Control Switch. Repair or replace
damaged remote control line and connectors.
See remote control system Operator's
Manual.