Miller 907759 Beknopte handleiding - Pagina 9

Blader online of download pdf Beknopte handleiding voor {categorie_naam} Miller 907759. Miller 907759 12 pagina's.

Pagina afdrukken

Getting Started

To access the service menu, press and hold the Adjust Control/Select Button for 5 seconds, then

release. Rotate the knob to scroll through the menu items. Press and release the control to access

the options and information within each menu item.

Rotate the control to scroll or change value. Press and release control to save selection. After 5

seconds of inactivity, the menu will time out and the selection will be saved.

Menu Item

HOUR MTR

ENG OIL

COMP OIL

RPM DISP

RPM SET

STOP TIME

MIN PRES

MAX PRES

SOFT WARE

FACT RSET

Codes Shown on EnPak Remote Control Panel Display

You could see a code show up on the EnPak screen to let you know there is some type of issue.

Check the manual for error code reference to help repair the issue. Resetting of Charge/Weld codes

can be done by either: changing position of the charge/weld switch; change positions of the process

select switch; cycle unit power off/on. Resetting of Air Compressor codes can be done by switching

the compressor Off, then On.

(continued)

Service Menu

Selectable Item

Option(s)

– –

OIL HOUR

OIL SET

OIL RSET

OIL HOUR

OIL SET

OIL RSET

– –

AUTO

3600

2 to 30 min

90 psi up to 10 psi less

than max pressure

175 psi down to 10 psi

greater than min pressure

– –

RSET YES

RSET NO

Description

Displays the current Engine Hours.

Displays the current oil change countdown.

Sets the oil change interval.

Resets the oil change countdown.

Displays the current oil change countdown.

Sets the oil change interval.

Resets the oil change countdown.

Displays current engine RPM.

Enables auto speed function.

Locks engine speed at 3600 RPM.

Unit idle time before auto stop (adjustable in 1 min increments).

Minimum pressure to start air compressor (adjustable in 1 psi

increments).

Maximum pressure to stop air compressor (adjustable in 1 psi

increments).

Displays the current revision of firmware installed.

Resets all settings to factory defaults.

All settings remain at previous settings.