Miller FieldPro Remote Gebruikershandleiding - Pagina 3

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Miller FieldPro Remote. Miller FieldPro Remote 8 pagina's.

Pagina afdrukken
3.
Connecting Work Sense Lead To Remote
4
.
The work sense lead is required for op-
eration of the FieldPro Remote.
1
Lead
2
Ring Terminal 1/2 in.
If using a ring terminal, slide terminal onto
4.

Connecting To Power Source

6
.
The FieldPro Remote can only be
used with FieldPro power sources.
See welding power source Owner's
Manual for additional information on
safety, installation, operation, and
troubleshooting.
1
Power Source
2
TIG Torch (Shielding Gas Not
Shown)
3
1
2
5
post on the remote.
3
Wing Nut
Once terminal or wire is on post, tighten
wing nut.
4
Binding Post
FieldPro Remote Connection
3
Electrode Holder
4
Work Cable
Connect work cable to WORK (bottom)
output receptacle on the front of the weld-
ing power source. Attach work cable clamp
as close to the arc as possible.
5
Work Sense Lead
Attach work sense lead clamp next to the
work cable clamp. Connect the other end
2
5
5
Electrical Tape Or Heat Shrink
Tubing
If ring terminal is cut or broken, the bare
wire can be looped around the post and
tightened under the wing nut.
1
4
of the work sense lead to the binding post
on the side of the FieldPro Remote.
6
FieldPro Remote
Connect one end of the weld cable to
ELECTRODE (top) output receptacle on
the front of the power source and the other
end to the FieldPro Remote. Connect the
TIG torch or electrode holder to the other
side of the FieldPro Remote.
255 450-A
5
2
3
255 420-B
OM-257 886 Page 3