Miller 20 Series Gebruikershandleiding - Pagina 23
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Miller 20 Series. Miller 20 Series 36 pagina's.
Pagina afdrukken
5-9. Installing And Threading Welding Wire
2
1
A
B
C
WOOD
3
Tighten
1
Retaining Ring
2
Hub Tension Adjustment Nut
If necessary, move hub on support
for use of different size wire spool.
Remove retaining ring, and install
spool so hub pin fits spool hole.
Reinstall retaining ring.
Adjust tension nut so wire is taut
when wire feed stops.
3
Pressure Assembly
Adjustment Knob
Lay gun cable out straight.
A
Open pressure assembly,
hold wire tightly, and cut off
end. Push wire through guides
into gun.
B
Close and tighten pressure
assembly. Press JOG button
until wire comes out gun.
C
To adjust drive roll pressure,
press gun trigger to feed wire
against wood surface. Tighten
knob so wire does not slip.
Cut off wire. Close door.
Tools Needed:
15/16 in.
Ref. 802 356 / S-0627-A
OM-281138 Page 19