Miller Spoolmate 150 Gebruikershandleiding - Pagina 22
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Miller Spoolmate 150. Miller Spoolmate 150 36 pagina's.
5-2.
Controls For Millermatic 211 Auto-Set
3
1 Shielding Gas Cylinder
For shielding gas connections, see welding
power source Owner's Manual.
2 Valve
Open valve on cylinder just before welding
Close valve on cylinder when finished
welding.
3 Voltage/Material Thickness Control
Turn control clockwise inside white scale (1-
10) to increase voltage (see weld parameter
chart in welding power source).
4 Process Select Control
OM-272384 Page 18
4
9
2
1
Rear View
Turn control to select desired weld process.
5 Perform Motor Calibration
See the Millermatic 211 Owner's Manual for
Spoolmate Motor Calibration procedure.
6 Wire Speed/Wire Diameter Control
Turn control clockwise inside white scale
(10-100) to increase wire feed speed. (see
weld parameter chart in welding power
source).
7 Over Temperature Light
If unit overheats, light turns on and output
stops. Allow unit to cool before resuming
Models
™
6
operation. This light will also communicate
additional unit errors.
8 Power Light
Power light illuminates when the unit is
turned on and powered up.
9 Power Switch
Use switch to turn unit On or Off.
10 Trigger
Press trigger to energize welding power
source contactor, start shielding gas flow,
and begin wire feed.
8
7
3
10
274604-A / 270208-A
OM-272 384 Page 5