Miller 1501 Gebruikershandleiding - Pagina 4

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Miller 1501. Miller 1501 8 pagina's. Rapid lock tripod series, 2-stage tripod (alloy) & 3-stage tripod
Ook voor Miller 1501: Gebruikershandleiding (8 pagina's)

Pagina afdrukken

Tripod Setup

Remove tripod from carry bag, undo clip on leg strap and

stand on a level surface (if possible). Depending on

Fig 1 Collapsed

surface, screw out rubber foot for non-scratch contact

position

to interior or hard surfaces or screw in for a spike on

exterior soft surfaces such as dirt or sand.

Note: Leg angle adjusters are spring loaded and self

adjusting. Do not hold leg angle adjuster up while spreading

tripod legs as this may cause leg angle adjusters to operate

improperly and potentially damage the tripod.

Maximum Height

(Leg angle adjustment is not required)

1 Separate legs slightly so they are

parallel.

2 Working with each leg

individually, grip concentric locks

Fig 2 Spread

and release one turn (see leg

position

lock direction label on leg).

3 Extend to desired length and

turn each concentric lock to

engage firmly. Repeat process

for remaining legs.

4 Spread tripod legs (Fig. 2)

and adjust leg length to

ensure tripod bowl is

approximately level.

5 Level the fluid head using bubble level and ball

levelling feature of fluid head.

Fig 3 Leg angle adjuster

raised

Minimum Height

Note: It is recommended that

minimum height position is used only

with legs at their shortest length.

1 Pull up leg angle adjuster until it locks into a raised

position (Fig. 3). Repeat for all three locks.

2 Holding one leg on the ground pull the remaining two

outward, spreading the tripod to its lowest position. Leg

angle adjuster will automatically engage the leg to hold

Fig 4 Lowest height

position

the tripod at its lowest

height position (Fig. 4).