Miller DS5 Gebruikershandleiding - Pagina 3

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Miller DS5. Miller DS5 4 pagina's. Miller tripod/video equipment operator's manual ds5
Ook voor Miller DS5: Gebruikershandleiding (9 pagina's)

Pagina afdrukken

2. Mount Your Camera

1/4" and pin adaptor

The DS5 is equipped with a Quick

carriage

release plate housing a removable _" &

pin carriage. The _" & pin carriage is

Camera plate

captive in the plate and is the standard

mounting method for palmcorders and

Pan handle clamp

lightweight MiniDV camcorders.

Quick release

2.1Lock PAN and TILT LOCKS (rotate

Pan handle

both levers clockwise until firm).

2.2Remove CAMERA PLATE from

CAMERA PLATFORM by unlocking

SLIDE LOCK. The rear of the Camera

plate (with captive _" & pin) will flip

out of the platform.

2.3 Attach CAMERA PLATE by fastening

Bubble level

CAMERA SCREW & locating pin into

camera's base. N.B. there is about

20mm of sliding movement on the

75mm claw ball

camera plate to allow for optimum

Centre of Gravity (CofG) placement

of the camera on the fluid head.

2.5Attach camera to fluid head by

inserting the camera plate (front first)

into the space in the platform, then

push the camera plate down into the

rear to engage the locking

Clamp nut

mechanism. The camera plate should

be securely held in the platform by

pushing the yellow locking lever

(beneath the platform) until it is tight.

Cleaning

WARNING: Do not immerse a fluid head in any liquid.

WARNING: Do not use stiff brushes, abrasives or solvents.

The DS10 (DS20) fluid head features protective coatings, dust and

moisture seals and anti-corrosive fittings to ensure long and

trouble-free operation in harshest of location environments. To

ensure optimum performance throughout the life of the head Miller

recommends regular cleaning.

When the fluid head has been used in harsh environments (such as

sand, mud or salt water spray), wipe over with a soft damp cloth as

soon as possible. Use a soft brush to clean crevices. Remove and

clean CAMERA PLATE.

Storage

When storing for extended periods: clean fluid head and store in a

safe, dry place, away from direct sunlight. The fluid heads can be

stored horizontally or upright. However, it is not advisable to store

the head for extended periods with the tilt locked in an extreme

position, either forward or backward.

Maintenance

With the exception of cleaning, the DS10/ DS20 fluid head does not

require additional maintenance. Miller recommends periodic

servicing by a Miller Authorised Agent. Miller Authorised Service

Agents must carry out all service and repair work. Failure to

observe this requirement may void warranty.