Miller ICE-27C Gebruikershandleiding - Pagina 19

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Miller ICE-27C. Miller ICE-27C 38 pagina's. Air-cooled torches for plasma arc cutting

Pagina afdrukken
Miller ICE-27C Gebruikershandleiding
21. Troubleshooting For 25, 27, 40, 50, 55, 80, And 100 Ampere Torches
Trouble
Power source Cup trouble light On; no
cutting output.
Sparks come out top of cut, or cut is not
clean.
Arc goes out while cutting.
Arc goes on and off while cutting.
Tighten cup onto torch and reset Power (see Section 15).
Check torch connections on power source. See power source Owner's Manual.
Torch travel speed too fast; reduce travel speed (see Section 13).
Clean or replace worn consumables as necessary (see Section 17).
Metal being cut is too thick; increase output control setting. See power source Owner's Manual.
Be sure work clamp is securely attached. See power source Owner's Manual.
Make sure torch tip is contacting metal while cutting.
Be sure work clamp is securely attached. See power source Owner's Manual.
Clean or replace worn consumables as necessary (see Section 17).
Torch travel speed is too slow; increase travel speed (see Section 13).
Clean or replace worn consumables as necessary (see Section 17).
Be sure work clamp is securely attached. See power source Owner's Manual.
Remedy
OM-1593 Page 19