Miller Invision 352 MPa Auto-Line CE Gebruikershandleiding - Pagina 39
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Miller Invision 352 MPa Auto-Line CE. Miller Invision 352 MPa Auto-Line CE 44 pagina's.
Ook voor Miller Invision 352 MPa Auto-Line CE: Gebruikershandleiding (48 pagina's), Gebruikershandleiding (44 pagina's)
Pagina afdrukken
8-4. Troubleshooting
Trouble
No weld output; unit completely inop-
erative.
No weld output; meter display On.
Erratic or improper weld output.
No 115 volts AC output at optional
duplex receptacle.
No 24 volts AC output at Remote 14
receptacle.
Notes
.
A complete Parts List is available at www.MillerWelds.com
Place line disconnect switch in On position (see Sections 5-7 and 5-8).
Check and replace line fuse(s), if necessary, or reset circuit breaker (see Sections 5-7 and 5-8).
Check for proper input power connections (see Sections 5-7 and 5-8).
Input voltage outside acceptable range of variation (see Section 5-6).
Check, repair, or replace remote control.
Unit overheated. Allow unit to cool with fan On (see Section 4-9).
Use proper size and type of weld cable (see Section 5-2).
Clean and tighten all weld connections.
Check for correct polarity.
Reset supplementary protector CB1 (see Section 5-5).
Reset supplementary protector CB2 (see Section 5-5).
Remedy
OM-246193 Page 35