ABB Endura AZ40 Gebruiksaanwijzing - Pagina 2

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} ABB Endura AZ40. ABB Endura AZ40 16 pagina's. Oxygen and carbon monoxide equivalent (coe) analyzer
Ook voor ABB Endura AZ40: Handmatig (16 pagina's), Gebruiksaanwijzing (20 pagina's)

Pagina afdrukken

3 Health & Safety

3.1 Safety precautions

Be sure to read, understand and follow the instructions

contained within this document before and during use of the

equipment. Failure to do so could result in bodily harm or

damage to the equipment.

WARNING – Bodily injury Installation, operation,

maintenance and servicing must be performed:

— by suitably trained personnel only

— in accordance with the information provided in

this document

— in accordance with relevant local regulations

3.2 Potential safety hazards

3.2.1 Process conditions and requirements

WARNING – Bodily injury

Environmental conditions

— High air / equipment / structure temperatures, poor

air quality and adverse environmental conditions

may be present when the process is running.

— It is recommended that the process is shut down

before performing these procedures.

— The process must be cool enough to enable

shutdown, disconnection and removal of the sensor

in a safe manner and in accordance with relevant

local regulations.

— Appropriate PPE, including mask and goggles must

be worn when preparing the process for these

procedures.

INS/ANAINST/007-EN Rev. B | Endura AZ40 | Sensor assembly | Orifice and seals kit

3.2.2 Endura AZ40 sensor – fibrous material in probe

assembly

WARNING – Serious damage to health

Fibrous material

— The sensor and probe assemblies (standard and

high temperature versions) contain fibrous material

that can be a health hazard if airborne.

— The material, predominantly – aluminosilicate

refractory fibres, CAS 142844-00-6. Refractory

ceramic fibres (RCF) are classified as:

– Category 1B carcinogen under regulation (EC)

No 1272/2008 – the classification, labelling and

packaging regulations.

– Category 2B carcinogen by inhalation by The

International Agency for Research on Cancer

(IARC).

— When removing the sensor cover and subsequent

maintenance activities, exposure to the airborne

fibres could occur. ABB have conducted air

sampling assessments within the breathing zone of

the operator and have identified that an exposure

limit of 1 fibre / cubic centimetre is unlikely to occur.

— Exposure to any carcinogen must be kept as low as

reasonably practicable.

— Appropriate PPE defined below, must be

worn when working with probe assemblies

(all installation, replacement, maintenance

procedures):

– A face fit tested, half mask conforming to EN140

(or equivalent) with a level 3 particulate filter

conforming to EN 143 (or equivalent).

– Disposable protective coveralls in accordance

with Type 5 ISO 13982-1:2004 (or equivalent).

– Goggles and gloves.

3.2.3 Endura AZ40 sensor / probe – installation to

pressurized process

DANGER – Serious damage to health / risk to life

Pressurized equipment – do not install / remove /

the sensor / probe if the process is at positive

pressure

Installation, operation, maintenance and servicing of

pressurized equipment must be performed:

— by suitably trained personnel only

— in accordance with the information provided in this

document

— in accordance with relevant local regulations

— when process conditions are suitable to allow

enough to enable installation / maintenance