Aquaparx RIB-230 Gebruikershandleiding - Pagina 4

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Aquaparx RIB-230. Aquaparx RIB-230 5 pagina's.

How to repair small punctures:

Check that the tube is fully deﬂated and lies ﬂat.

1. Prepare a round patch no less than 3 inches or 7 centimeters in diameter.

2. Clean the patch and the area surrounding the leak with Alcoholic solution.

3. To contain excess glue, use masking tape to tape off the area around the patch.

4. Apply 3 thin, even coats of repair kit adhesive to both the surface of the boat and the patch. Wait 5

minutes between each coat.

5. After the 3rd coat, wait 10-15 minutes before applying the patch. Use a hand roller to apply the patch

evenly.

6. Wait 24 hours before re-inﬂating.

General:

Please mail us a copy of your purchase. You will void your warranty by not ﬁling the purchase with us. Be

sure to enter the Serial #(HIN code = the 12 digit number) you will ﬁnd on the inner side of the rear tube or

capacity plate.

General Care and Preservation:

There is very little that you have to do to keep your boat in good condition for many years. You may store it

inﬂated or deﬂated. If you leave it outside, raise it up off the ground. If it is going to be in left outside, cover it

with a tarp (we do not recommend hanging the boat). If you leave it in the water, you will probably have to

drain out rainwater at times. If you store it inside, we suggest you a cool and dry place, making sure the boat

is clean and dry before you pack it up - or cold can accumulate. That is all you need to keep your boat in mint

condition for years to come. Most dirt can be removed with a garden hose, a sponge and mild soap. Do not

sprinkle with powders. Do not store in an area where it is likely to be exposed to extreme temperatures

(above 60°C or below -20°C).

Various General:

• Perform all of your repairs in a well-ventilated area.

• Avoid inhaling glue vapours.

• Avoid contact with the skin or the eyes.

• Keep all repair materials away from the reach of children. The repairs on the welds must not be glued. Only

the manufacturer can perform repairs on the welds themselves.