Burks 104300 Installatie- en bedieningshandleiding - Pagina 6

Blader online of download pdf Installatie- en bedieningshandleiding voor {categorie_naam} Burks 104300. Burks 104300 12 pagina's.

Adding Boiler Compound:

BOILER COMPOUND SHOULD NOT BE INTRODUCED

INTO SYSTEM ON THE SUCTION SIDE OF PUMP. Boiler

compound often coagulates when it contacts hot water

and becomes abrasive, and will damage the race way and

impeller of the pump.

Draining the Pump:

To drain pump, remove 1/4" pipe plugs from bottom of

pump frame and pump case. After pump has drained, start

pump to discharge liquid from impeller. Always protect the

pump, piping, tank, etc., from freezing - or drain the system

when there is a chance of freeze-up.

Impeller Adjustment:

After years of service, it may be desirable to adjust the

impeller to compensate for water wear. If this is necessary,

because of reduced capacity or pressure.

Motor:

Keep motor clean and dry. It is drip-proof when installed

horizontally and the windings are protected from excess

humidity, but extreme conditions should be avoided when

possible. If motor fails to run, be sure power is on, all

switches or electrical controls are closed, fuses are in

order and all electrical connections are tight. (Motor must

be repaired by Authorized Repair Station under terms of

quarantee.)

Failure to Pump:

If the motor runs, but no water is pumped, be sure pump is

primed, that there are no air leaks in suction piping, that all

gate valves are open and all check valves operate.