Aquaport AQP-20SIL Handleiding voor installatie en gebruik - Pagina 13

Blader online of download pdf Handleiding voor installatie en gebruik voor {categorie_naam} Aquaport AQP-20SIL. Aquaport AQP-20SIL 16 pagina's. Signature filtered water cooler

Pagina afdrukken
Problem
Possible Causes
If Filter bottle O ring is not correctly
installed leaking may occur.
Leaking from
top/bottom of unit
Drain plug at bottom of unit not closed fully.
Unit not plugged into wall socket or wall
Not cooling
socket not switched on
Due to transport or knock to side panel, the
Noise from fan
fan may have moved to a different position
- this will cause a noise.
New, new silicone, new tap.
Bad taste
from cooler
Build up of bacteria.
What To Do
Remove filtered water chamber off unit and reinstall the
filter bottle O ring. WARNING: Filter bottle O ring may
come off when you remove the filter bottle from the cooler,
please ensure it is located correctly before reinstalling
the filter bottle.
Check drain plug located at bottom of unit is closed and
sealed completely.
Check connection to wall socket.
Check power switch on back of unit is on.
Unit uses thermoelectric chip to chill water, performance
of unit is dependent on room temperature. Cooing light will
remain on when unit is attempting to cool water to optimal
temperature.
Call customer care 1300 764 325
Replace filter, remove filter bottle and wash thoroughly. Place
a tablespoon of bi-carb soda mixed with warm water approx.
1 litre, pour in cooler until the tap reservoir is full, leave
overnight and then flush 1-2 litres of filtered water through
the unit until the bi-carb solution has been flushed clean.
INSTALLATION AND OPERATING INSTRUCTIONS 11