Aquaport DELUXE AQP-WCM Handmatig - Pagina 6
Blader online of download pdf Handmatig voor {categorie_naam} Aquaport DELUXE AQP-WCM. Aquaport DELUXE AQP-WCM 12 pagina's. Executive water cooler, cold and room
Pagina afdrukkenA. Executive Water Cooler Installation for Spring Water bottles.
Please follow the instructions below if you are using a spring
water bottle.
Do not turn on the water cooler until the following instruction
have been followed.
1. Vertically insert a spring water bottle into the bottle
supporter on top of the water cooler, the spike will pierce the
bottle cap. You will see bubbles appear inside the bottle, wait
until the bubbling has stopped before dispensing water form
both taps
Note: If you are applying a spring water bottle to the water
cooler for the first time and you do not see any bubbles appear
inside the bottle, open both taps until the bubbling starts and
water flows from both taps. Refer to the trouble shooting guide
for more information.
2. Once the bubbling has stopped, drain 1-2lts of water from
both taps.
Note: The water cooler has been flushed before it left the factory
however we strongly recommend 2-3lts of water is flushed
through the unit before using.
4 INSTALLATION AND OPERATING INSTRUCTIONS
3. Insert the power plug into the wall socket, and turn the green
power switch ON. The power switch is situated at the rear of
the unit.
4. At the front of the unit there are 3 indicator lights, the
red LED on the right is the power light and will continually
illuminate while the unit is turned on. The Green LED cooling
light on the left will illuminate when the compressor is
running and cooling the water. When cooling is finished the
Green cooling LED light will turn off and the middle Yellow
Auxiliary LED light will illuminate until cooling is required
again.
5. When the unit is turned on for the first time, allow the unit to
cool the water for 1-2 hours before dispensing cold water.
B. Executive Water Cooler Installation for Filter bottle.
Please follow the instructions below if you are using a filter
bottle.
Do not turn on the water cooler until the following instruction
have been followed.
1. Remove the bottle support and spike from the water cooler.
See figure 1 on page 5.