Aquarium Co-Op Heater Instructies

Blader online of download pdf Instructies voor {categorie_naam} Aquarium Co-Op Heater. Aquarium Co-Op Heater 2 pagina's.

Note:

•

Do not attempt to disassemble. Disassembling will void the 1-year warranty.

•

Do not plug in the unit unless the heater is completely submerged underwater.

•

Do not let the temperature controller and power plug get wet.

Installation Guide:

1. Place the heater inside the aquarium

without plugging it in yet. Position it in either

a vertical or horizontal orientation. To

prevent hot spots, put it in an area with

good water flow. The heater must be

completely covered in water and not buried

in the substrate.

2. After the heater has been submerged in the

water for 20 minutes, plug it into an

electrical outlet. To prevent water from

flowing down the heater's power cable into

the electrical outlet, create a "drip loop" with

the power cord so that part of the cord dips

down lower than the outlet.

3. When the heater is first powered on, the blinking temperature display on the heater shows the desired

temperature in degrees Fahrenheit (°F). After 3 seconds, the temperature display stops blinking, and

the current water temperature is shown. The heating indicator light glows red when the unit is actively

heating the water.

Aquarium Co-Op Heater Instructions