Aquasana AQ-UV-10C Gebruikershandleiding - Pagina 12
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Aquasana AQ-UV-10C. Aquasana AQ-UV-10C 20 pagina's. Whole house uv filter
Ook voor Aquasana AQ-UV-10C: Bediening en installatie-instructies (16 pagina's)
INSTALLATION STEPS
10
9
Insert UV Lamp
Always hold UV Lamps by their ceramic ends, not by
the Lamp bulb. Again, use cotton gloves for this step.
Remove the UV Lamp from its packaging.
Insert the UV Lamp into the UV Reactor.
NOTE: DO NOT touch the key's exposed contacts.
UV Lamp Connection
10
1. Plug the UV Lamp Connector
into the UV Lamp. Note the
keying for proper alignment.
2. Insert the UV Lamp Connector
into the Gland Nut and turn
the connector approximately
¼ turn to lock the Connector
to the Gland Nut.
11
Ground Screw Connection
Tighten the captive ground screw to
the ground lug on the UV Reactor using
a Phillips Head Screwdriver to ensure
proper grounding as shown.
Plug-In UV Filter
12
Your system is now ready to be plugged into the appropriate GFCI
protected outlet. Refer to the following System Disinfection section
before any water is allowed to flow through the system.
WARNING
1
2