Diamond FE-30 ELT Handmatig - Pagina 7

Blader online of download pdf Handmatig voor {categorie_naam} Diamond FE-30 ELT. Diamond FE-30 ELT 12 pagina's.

CONNECTION OF THE ELECTRIC CABLE TO THE ELECTRICITY

Instalation of electric feeder - This feeder must be separetely protected by a safety fuse

according to the specific electric stream which depends on the wattage of the instaled device.

Check the wattage on the label at the back of the device. Connect the device directly to the

electricity but you must put the switch between the device and electric net. The switch must

be placed in min. distance 3 mm between the particular contacts according to the standards

and loading. The feeder of grounding (yellow-green) cannot be interrupted by this switch. In

every case feeding cable must be placed so that no point of the cable will reach the

temperature which is 50°C higher than the temperature of the surrounding. Before connecting

the device check that:

• safety fuse of the feeder and inner mains can stand the loading of the device (see label

of the matrix)

• mains are equipped with effective grounding according to standards ( SN) and

conditions given by law

• socket or switch of the feed is well accessible from device

We refuse any responsibility in case of not respecting above mentioned rules.

Before the first use it is necessary to remove all the protection foil and to clean the device -

see chapter "cleaning and maintenance".

We recommend to have the device checked once a year by the proffesional service. Only

qualified or competent persons can do interventions in the product.

INSTRUCTION FOR USE

Attention!Before the first use of the device you must remove protection foil from all surfaces

and wash the device with water with detergent. Than splash it with clean water. Use the

device under supervision. Never use the device without oil or if the level of the oil is lower

then min. line - danger of fire. If the oil is dirty or you use the oil longer time it may cause

boiling over.

Do not fry more then 1 kg of food together in one bath.

Fill the device with frying oil not higher than the line on the side. Switch on with main switch

(B) turn the knob (E) to required position between 90°C - 180°C. Pilot lamps (C) and (D)

will light. Pilot lamp (C) lights when the device is in elektricity and switched on. Pilot lamp

(D) lights when the thermo spirals are on. Pilot lamp (D) goes out when the device reaches

required temperature. Switch the device off by turning the knob (E) into position "0" and

switch over the switch (B) into position "0".