AquaScape 96031 Instructie- en onderhoudshandleiding - Pagina 5
Blader online of download pdf Instructie- en onderhoudshandleiding voor {categorie_naam} AquaScape 96031. AquaScape 96031 20 pagina's. Automatic dosing systems for ponds/ fountains
Ook voor AquaScape 96031: Instructies en onderhoud (16 pagina's), Instructies en onderhoud (20 pagina's), Instructie- en onderhoudshandleiding (20 pagina's)
Pagina afdrukken
5. Attach the included discharge tubing to the fitting on the
side of the control panel. Simply insert the tubing into
the fitting until it stops. The discharge tubing can either
be installed directly into the pond or fountain or installed
using the included output hose holder. The output hose
holder can be easily attached to plumbing or other
round surfaces. Refer to the installation diagrams on the
following page for more information.
Note: Install the system as close to the water feature as
possible to minimize the distance your water treatment
needs to travel.
5
6. Using the plus or minus buttons on the top of the
control panel, select the proper amount of gallons to be
maintained. If you are treating a fountain or small water
feature with less than 500 gallons, we recommend using
the 500 gallon setting. If the fountain or water feature
contains more than 500 gallons of water capacity,
increase the setting to the proper gallonage.
6
To Calculate Pond Size in US Gallons:
Length (in feet) x Width (in feet) x Average Depth (in feet) x 7.48
TIP: For new or problem ponds and fountains, we
recommend using the X2 button for the first two
weeks of operation.
☎
www.aquascapeinc.com |
☎
CAN 1-866-766-3426 |
US 1-866-877-6637
7. Priming Mode - When first setting up the system or when
adding a new water treatment pouch, the system will need
to be primed in order to push the water treatment through
the length of output tubing. To enter the priming mode,
hold the x2 button for 3 seconds until the LED indicator
light begins to flash. The system will begin to slowly prime
itself at this time. The priming mode will automatically turn
off after approximately ten minutes, returning to normal
operation. The priming mode can be exited at any time by
pressing the x2 button while the unit is priming.
7
8. Be sure to inspect your dosing system often to verify that
the treatment pouch is not empty and ensure proper
functionality of the system. Use the chart on page 8 of this
manual to approximate how often you will need to replace
your selected water treatment.
5