AquaScape 17510 Installatie-instructies

Blader online of download pdf Installatie-instructies voor {categorie_naam} AquaScape 17510. AquaScape 17510 2 pagina's. Statuary pump 75-145 gph

Pagina afdrukken

Statuary Pump

75-145 gph Installation Instructions

PaCkage InCludes:

• 75 or 145 gph Statuary Pump

• Instructions for Use

Features

• Fully submersible and energy efficient

• Powers ornamental fountains and statuary

Congratulations on your purchase of

this submersible pump.

You will find this pump ideal for use in small

ornamental fountains and statuaries. These pumps

are very energy efficient and designed to operate

Installation

1) If a fountain is not required, connect 1/2" hose

directly to the outlet adapter and secure with

hose clamp.

2) Plug pump cord into grounded outlet. Ensure

cable is protected — keep away from children

and garden hazards.

3) If fountain is in use, ensure fountain head is

above water level.

4) For proper operation, ensure that inlet is filled

with water.

Pump Performance

Model

gph full

Cord

open

length

75 gph

145 gph

145

Troubleshooting

Reduced Flow:

• Check pump and impeller for any blockages. It may

be necessary to take the impeller and prefilter out

and clean them.

• Check pipe and plumbing for any kinks or blockages.

Item #17510.11400.052006

• Prefilter system built in prevents clogging

• Fish safe, environmentally friendly materials

fully submerged. Made with environmentally friendly

materials, they are fish safe. The pumps are fitted with

a pre-filter system to prevent clogging and wear on the

impeller. The motors are epoxy encapsulated, not oil

filled, U.L. and C.U.L. approved.

Maintenance

1) Remove pump from electrical supply.

2) Wash pre-filter in fresh, running water. Never use

chemical detergents when cleaning. Handle filter

sponge material carefully.

3) Remove impeller, inspect and clean in running

water; replace if worn or damaged.

4) Reassemble pump; reconnect to electrical supply.

MaInTenanCe nOTes:

• Check cord periodically for sharp bends and correct.

• If pump is taken out of service, flush with fresh water and

allow to drain dry prior to storage.

gph

Max

Tubing

@ 2'

@ 4'

Head

size

2.6 ft.

1/2"

135

3.6 ft.

1/2"

Pump is not pumping:

• Make sure nothing is blocking the impeller. It may be

necessary to clean pump.

saFeTY COnsIdeRaTIOns

• This product must be installed on an electrical circuit protected by a Ground Fault Circuit

Interrupter (GFCI). Refer to your electric supply dealer for details.

• If you have any questions or doubts about this product, consult a qualified electrician.

• Do not lift the pump by the power cord — it is not designed for portable use.

• Always disconnect from electrical supply before attempting to service or perform

maintenance procedures.

RePlaCeMenT PaRTs

To order replacement parts, contact your local Aquascape™ retailer.

Replacement Part

75 gph Impeller

145 gph Impeller

Watts

size

Code

Base

Feet

YEAR

WARRANTY

GARANTIE

Item #

27500

DE 1 AN

20249

YEAR

WARRANTY

This Staturary Pump #17510 is warranted against

defects in materials or workmanship for a period of

GARANTIE

24 months starting at the date of purchase by the

DE 2 ANS

customer. This is the only warranty applicable for

this product. Our obligation under this warranty is

limited to the repair or replacement of the product

if it fails to operate. Neither Aquascape™, Inc. nor

the seller is liable for injury, loss or damage related

YEAR

to the use of the product. However, this limitation is

not applicable in some states.

The warranty is void if any of the following is found:

1) Abuse of product by the customer.

WARRANTY

2) Product connected to an electrical supply other

than specified.

3) Power cord cut to a length of less than three feet.

4) For pumps: (a) sealed motor housing opened;

GARANTIE

(b) pump operated dry, with fluid supply shut

DE 3 ANS

off and (c) pump used to circulate material other

than fresh water, light oils or other mild liquids at

approximately room temperature.

Outlet

Pump Cover

Motor

Pre-Filter

Impeller

Made in Italy for

Aquascape, Inc.

St. Charles, IL 60174 • Brampton,ON, L6T 5V7

www.aquascapeinc.com

IDD 06044481-ADI B060201