AquaScape 91104 Instructie en onderhoud - Pagina 5
Blader online of download pdf Instructie en onderhoud voor {categorie_naam} AquaScape 91104. AquaScape 91104 9 pagina's. Adjustable flow solids-handling pond pump
Ook voor AquaScape 91104: Instructies en onderhoud (20 pagina's), Instructie en onderhoud (16 pagina's)
Pagina afdrukken
Replacing Pump in Cage
• Replace the pump into the lower cage and secure in
place with the brackets. Also replace the power cord in
the strain relief.
• Reinstall filter cage and close all 5 tabs.
Winter Storage
• The pump can be run during freezing weather if desired
but should be removed if shutting down the pump for the
winter. Disconnect the threaded collar on the discharge
fitting and remove the pump from the pond (be careful
not to lose the flat rubber washer). Clean the pump and
cage screens with fresh water and store the pump in a
frost-free location.
Troubleshooting
• Reduced Water Flow
– Pump or plumbing may be clogged. It may be necessary
to clean the pump cage screens and impeller.
• Pump Hums and Doesn't Push Water
– Pump or plumbing may be clogged. It may be
necessary to clean the pump cage screens and impeller.
– Remove the water chamber cover and inspect and clean
the impeller rotor assembly and internal pump body.
– Make sure nothing is blocking or wrapped around the
impeller.
– Make sure the pump is receiving the correct voltage.
• Pump Not Working
– The ground-fault circuit-interrupter (GFCI) may
have tripped.
– The pump is not receiving the correct voltage.
• Remote Control Not Working
– Check to make sure the switch located on the Receiver
is in the remote control position. See page 6.
– Check the label on the back of the receiver and
transmitter to make sure they are paired to the
same frequency.
– Check to make sure the remote control battery is
installed properly. Replace battery if needed.
Warranty
3 YEAR WARRANTY
The AquascapePRO AquaForce
®
Adjustable Flow Pump is guaranteed for three years from date of purchase.
Proof of purchase required. Warranty does not cover damage resulting from negligent handling, misuse or lack of
reasonable maintenance or care. Warranty is valid against defects due to material and the company's workmanship
only. The sole obligation shall be to replace the defective unit with a suitable replacement unit. Units should be
checked for proper operation prior to returning as defective. No liability for loss or damage of any nature
or kind, whether arising out of or from the use of the product, whether defective or not defective, is assumed by
Aquascape, Inc. or its affiliates.
☎
8
3
Replacement Parts
3
2
AQUAFORCE PRO
PUMPS Replacement Parts
®
Diagram
Item #
Product
Numbers
91075
AquaForce
®
Replacement Cage Discharge Fitting Kit
91077
AquaForce
®
3600/5200 Replacement Water Chamber Cover
1
91096
AquaForce
4000/8000 (G2) Replacement Pump Cage Kit
®
91079
AquaForce
(G2) Replacement Cage Clip Kit
®
91101
AquaForce
PRO Replacement Impeller Kit
®
AquaSurge
PRO/ AquaForcePRO Pump Remote
®
4
45029
and Receiver Kit (G2)
x 5
US 1-866-877-6637 |
☎
CAN 1-866-766-3426 | www.aquascapeinc.com
I N S T R U C T I O N S
1
2
4
AquaForce
Adjustable Flow Pump
1
1
6
5
4
x 5
Pompe de filtrage
et cascades avec
télécommandé,
submersible et
résistante au
colmatage
3
Pour les modèles :
4000-8000
•
(article n
91104)
5
o
2
Conçue pour une
utilisation continue
E T
6
®
3
2
E N T R E T I E N
3
www.aquascapeinc.com