Chuango PIR-926 Gebruikershandleiding - Pagina 2

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Chuango PIR-926. Chuango PIR-926 2 pagina's. Solar-powered dual-tech motion detector
Ook voor Chuango PIR-926: Gebruikershandleiding (18 pagina's)

Pagina afdrukken

Working Mode Selection

After the battery is loaded, the detector enters lmin self-testing

with the red and orange LED flashing continuously, and then it

starts to work according to the pre-set working mode.

Testing Mode

Power Saving Mode

Testing mode (default setting):

The detector detects once every 10

seconds.

Power saving mode:

The detector enters a 5-minute testing mode

firstly, and then switches to power saving mode.

If the detector detects movements twice in 5 minutes, it

automatically goes into asleep state. If there is no movement

detected in next 5 minutes, it will switch from asleep state to arm.

As long as there is a movement detected within 5 minutes, the

duration of power saving mode will be extended.

Note:

It is suggested to set the detector in power saving mode for daily use to save

power.

Test

Remove the battery activation strip. After red and orange LED

flash continuously for lmin, it enters working state. By then, put

the detector on a shelf, walks from the left to right(or right to left)

within the detection scope to trigger it, red and orange LED will

flash once. This indicates the detector is working properly.

Installation & Notices

Installation steps:

1. Make the attachment bracket and base apart.

2. Fix the base on the right place (see notices).

3. Tighten the attachment bracket with the detector.

4. Tighten the attachment bracket with the base and adjust to

proper detecting angle.

Notices:

1. It is recommended to mount the detector at height of 2m from

the ground.

2. The detector is more sensitive to cross movement than vertical

movement, so it is suggested to mount it facing vertical to the

walking direction of people.

3. Please avoid big objects in front of the detector which will

influence the detection.

4. Please avoid any cases that pets can climb over to avoid false

alarm.

5. As it is a solar-powered detector, please install it where adequate

sunlight is ensured.

Ground

Connect to Control Panel

Make sure the control panel is in pairing state, trigger the detector

to alarm until the panel gives out a beep, which indicates the

connection succeeded. Arm the system, trigger the detector

again, the siren of control panel will hoot which confirms the

connection is successful.

Specifications

Power supply:

18650 3.7V 1800mAh rechargeable lithium battery

<0.16mA

Standby current:

2000LX illumination >4mA

Solar panel output current:

<180 days

Battery standby time:

8m/110

Detection scope:

<80m (in open area)

Wireless transmitting distance:

315MHz or 433.92MHz (±75KHz)

Radio frequency:

Operating condition:

C~+55

Temperature -l0

Relative humidity <80% (non-condensing)

PC+ABS+ANTI-UV

Housing material:

186 x 200 x 125mm

Detector dimensions (L x W x H):

75 x 72 x 155mm

Bracket dimensions (L x W x H):

Ver: PIR-926-UM-EN-Vl.0