AquaStar 2700 ES Handleiding voor installatie-instructies - Pagina 7

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} AquaStar 2700 ES. AquaStar 2700 ES 12 pagina's. Tankless water heater
Ook voor AquaStar 2700 ES: Handleiding voor installatie-instructies (8 pagina's)

Pagina afdrukken

Electrical connections

5.1

Electrical power supply

For

Warning:

disconnect the power supply cord to

the heater before any service or testing

is performed.

Warning:

This

electrically grounded in accordance

with the most recent edition of the

National Electrical Code. NFPA 70. In

Canada, all electrical wiring to the

heater should be in accordance with

local codes and the Canadian Electrical

Code, CSA C22.1 Part 1. Do not rely

on the gas or water piping to ground the

metal parts of the heater.

The water heater requires an electrical power supply

from a 120VAC / 60Hz circuit (with a dedicated outlet)

and must be properly grounded.

The heater is wired as shown in the wiring diagram of

the water heater installation manual.

Fig. 10 Connecting power supply cord

Power cord length: 3ft.

Note: Outlet appliance is plugged in to should be

clear from possible water damage.

Warning: Confirm that the water

heater is appropriately grounded and

that the installation meets all applicable

electrical

codes

installations.

B Refer to water installation manual to complete

installation of gas and water piping connections.

B Start and operate the water heater according to the

water heater installation manual. NOTE: Open the

control panel shield to access the controls of the

heater, see Fig. 3.

6 720 608 835

safety

reasons,

heater

must

for

outdoor

Electrical connections