Diamond Audio Technology D5 5.1 Gebruikershandleiding - Pagina 9

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Diamond Audio Technology D5 5.1. Diamond Audio Technology D5 5.1 17 pagina's. Professional reference series amplifier

Pagina afdrukken

Sub and Center Speaker Outputs

Front and Rear Speaker Outputs

R GAIN

R HP

POWER

SUB LP

SUB INV

FREQ

FL +

FL -

FR +

FR -

RL +

RL -

RR+

RR -

SUB

CNTR

SPEAKER WIRING

Diamond Audio recommends using speaker wire of at least 16 gauge. Lay out

the wire in the vehicle from the individual speaker locations to the amplifier(s).

Observe safe wiring precautions.

Your D5 Professional Reference Series Amplifier will accept speaker wire up to

10 gauge directly. Locate the speaker terminal block on the end of the

amplifier. Strip approximately 1/2 inch of insulation from the wire, insert the

wire into the terminal, and tighten the Allen screw. Repeat for all speaker

wires. Please observe our recommended minimum speaker impedances to

prevent possible damage.

Banana Jacks using up to 8 gauge wire can be inserted into the speaker block.

Remove the set screw completely and insert the Banana Jack into the end of

the block.

BRIDGING

Only the pair of sub channels are capable of bridging on the D5 5.1 Amplifier.

All other channels are designed for single channel use only. Bridging the sub

channels is accomplished by using the left channel positive (+) output

connection of the amplifier for the speaker positive and the right channel

negative (-) output connection of the amplifier for the speaker negative.

Note:

It is important that a 4 Ohm minimum total speaker impedance

load is observed when bridging the sub channels on the amp! If an

impedance load of less than 4 Ohms is used, you will eventually

damage your amplifier and void your warranty.

RCA INPUTS

CH 1/2 & 3/4 INPUTS

The RCA cables from your source unit or 5.1 processor should be inserted here.

SUB & CENTER CHANNEL INPUTS

The sub channel input is designed for input from your source unit if it is

equiped with a sub output. Otherwise, both the sub and center inputs must

come from a 5.1 processors output.

7 Diamond Audio Technology