Diamond Audio Technology D6 Series Gebruikershandleiding - Pagina 8

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Diamond Audio Technology D6 Series. Diamond Audio Technology D6 Series 12 pagina's. D6 series reference amplifiers
Ook voor Diamond Audio Technology D6 Series: Bedradingsschema (1 pagina's)

Pagina afdrukken

Diamond Audio Technology D6 Series Gebruikershandleiding

D6 300.4/600.4

Crossover Freq. Diagrams

Highpass (multiplier)

Lowpass

D6 1000.1/1500.1

Remote Gain

Both D6 mono block amplifiers come with a remote gain output. The remote gain module

(included) plugs into this output to allow for gain control away from the amplifier. When

you plug this module in, it replaces the gain from where it is set on the amplifier. Max

(all the way clockwise) on the module is set to whatever the gain on the amp is set to.

Note: Old D5 600.11200.1 remote gains do not work with D6 amplifiers.

Speaker Outputs

Although the D6 1000.1 and 1500.1 amplifiers have two sets of outputs, they are

mono-block amplifiers and the outputs can not be bridged. The two sets of outputs are

paralleled inside the amp to a single channel. This gives you ease during the installation

of multiple voice coils or woofers.

Note: It is important that a 1 Ohm minimum total speaker impedance load is

observed! If an impedance load of less than the above minimums is used, you will

eventually damage your amplifier and void your warranty.

RCA

INPUT

The RCA cables from your source unit should be inserted here.

MASTER OUT

This RCA output is used to provide a master signal to slave amplifiers.

SLAVE IN

This RCA input is used to receive signal from a master amplifier.