Diamond Audio Technology D7056 Installatiehandleiding - Pagina 9
Blader online of download pdf Installatiehandleiding voor {categorie_naam} Diamond Audio Technology D7056. Diamond Audio Technology D7056 11 pagina's.
Pagina afdrukkenCONTINUOUS RMS OUTPUT POWER
Note: Full Rated Power is generated at all voltages between 11 and 16VDC.
D7056
50W x 6 @ 4 Ohm Stereo
100W x 6 @ 2 Ohm Stereo
200W x 3 Bridged @ 4 Ohms (minimum impedance)
CROSSOVER SPECIFICATIONS
Quantity:
3 (1 for CH 1/2 INPUT, 1 for CH 3/4 INPUT,
1 for CH 5/6 INPUT)
Type:
Fully Independent and Selectable Highpass,
Lowpass, Bandpass or All-pass
Slope:
18dB/Octave
Alignment:
Butterworth
FUSE RECOMMENDATIONS
D7 Professional Reference Series Amplifiers, by design, require external fusing.
Research has shown that a circuit board mounted fuse can create a drop in
available DC voltage at the input of the power supply resulting in increased
current draw.
We recommend that you install the correct size fuse/holder combination to the
main power cable within 18 inches of the battery. This will protect your vehicle
from fire damage due to a short circuit to the chassis or vehicle body. If a single
amplifier is installed, follow the fuse recommendation below. If installing
multiple amplifiers, add up the total fuse ratings of all installed amplifiers. This
should be used as your main fuse rating.
Amplifier
D7056
Note: A main fuse must be installed within 18 inches of the positive
battery terminal.
2
Maximum Fuse Rating
100
SYSTEM DIAGRAM 3
Four Channel System
with Bridged Subwoofer
D7 six channel amplifier
Front RCA outputs of source unit to
?
channels 1/2 Highpass to a component set
Rear RCA outputs of source unit to
?
channels 3/4 Highpass to a set
of rear coaxial components
Subwoofer RCA outputs of source
?
unit to channels 5/6 Lowpass to
a bridged 4 Ohm subwoofer
19